Abbott Precision XceedPro Betreibershandbuch PDF herunterladen (Seite 70)

10-6

Questions? Refer to Page 10-10 for Technical Support Instructions.

Symptom/Error Message Explanation How To Respond

During Any Test:

The bar code just scanned was not accepted.

Possible reasons are:

•Theredscannerbeamdidnotpassacross

all the bars of the code.

•Thebarcodewasdamagedor

poorly printed.

•Thebarcodewasnotofthetypespecified

for this ID or lot number.

1. Rescan the bar code or manually enter the

ID or lot number.

2. Notify the system administrator. The

problem may be the printing of the bar

code or the setup.

The bar code just scanned is from a foil

packet of test strips that has expired.

1. Discard the expired test strips.

2. Repeat the scan with a new, unexpired foil

packet of test strips.

The ID or lot number just scanned or

entered is too long or too short, according

to format defined during the setup of this

monitor.

1. Verify and re-enter the ID or lot number

using the bar code scanner or keypad.

2. If the problem persists, notify the

system administrator.

The ID or lot number just scanned or

entered is not on the list of acceptable ID’s

or lot numbers defined for this monitor.

(The menu item 2 – Continue appear only

if this option is set to Warn.)

1. Press 1 to ReEnter the ID or lot number

using the bar code scanner or keypad.

Or,

Press 2 to Continue testing.

2. If the problem persists, notify the

system administrator.

The strip inserted is a Glucose strip, while

the monitor was expecting a Ketone strip

(or vice versa).

Press 1 to replace with the expected test

strip.

Or,

Press 2 to Exit.

Chapter 10: Troubleshooting

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 84 85

Kommentare zu diesen Handbüchern

Keine Kommentare

Abbott Precision XceedPro Betreibershandbuch Seite 70

Kommentare zu diesen Handbüchern